Sep-2026 FREE Cisco 300-730 PRACTICE QUESTIONS AND ANSWERS UPDATES [Q141-Q157]

Share

Sep-2026 FREE Cisco 300-730 PRACTICE QUESTIONS AND ANSWERS UPDATES

DEMO FREE BEFORE YOU BUY 300-730 DUMPS

NEW QUESTION # 141
Refer to the exhibit.

Based on the exhibit, why are users unable to access CCNP Webserver bookmark?

  • A. The user cannot access the URL.
  • B. The ASA cannot resolve the URL.
  • C. The bookmark has been disabled.
  • D. The URL is being blocked by a WebACL.

Answer: B

Explanation:
https://community.cisco.com/t5/network-security/missing-ssl-vpn-bookmarks/td-p/1597023


NEW QUESTION # 142
Which command must be configured on the tunnel interface of a FlexVPN spoke to receive a dynamic IP address from the hub?

  • A. ip unnumbered
  • B. ip address negotiated
  • C. ip address pool
  • D. ip address dhcp

Answer: B

Explanation:
interface Tunnel0
ip address negotiated
tunnel source GigabitEthernet1
tunnel mode ipsec ipv4
tunnel destination 1.1.1.5
tunnel protection ipsec profile IPSEC_PROFILE


NEW QUESTION # 143
An engineer would like Cisco AnyConnect users to be able to reach servers within the
10.10.0.0/16 subnet while all other traffic is sent out to the Internet. Which IPsec configuration accomplishes this task?

  • A.
  • B.
  • C.
  • D.

Answer: C


NEW QUESTION # 144
Which two tasks must be performed to implement a clientless VPN on the Cisco ASA? (Choose two.)

  • A. Configure a connection profile
  • B. Configure a language translation file.
  • C. Upload an AnyConnect Package.
  • D. Install an enrolled X.509 Certificate.
  • E. Configure a portal customization.

Answer: A,D


NEW QUESTION # 145
Which method dynamically installs the network routes for remote tunnel endpoints?

  • A. CEF
  • B. route filtering
  • C. reverse route injection
  • D. policy-based routing

Answer: C

Explanation:
Reverse route injection (RRI) is a method that dynamically installs the network routes for remote tunnel endpoints. The RRI feature allows the router to automatically learn the routes for the remote networks and automatically install these routes into the routing table. This eliminates the need for the administrator to manually configure and maintain the routes for the remote networks. This feature is commonly used in VPN environments, where the router at the VPN endpoint needs to learn the routes for the remote networks behind the other VPN endpoint. The other options such as policy-based routing, CEF, and route filtering are not used to dynamically install the network routes for remote tunnel endpoints Reference:


NEW QUESTION # 146
A network engineer is implementing a FlexVPN tunnel between two Cisco IOS routers. The FlexVPN tunnels will terminate on encrypted traffic on an interface configured with an IP MTU of
1500, and the company has a security policy to drop fragmented traffic coming into or leaving the network. The tunnel will be used to transfer TFTP data between users and internal servers. When the TFTP traffic is not traversing a VPN, it can have a maximum IP packet size of 1500.
Assuming the encrypted payload will add 90 bytes, which configuration allows TFTP traffic to traverse the FlexVPN tunnel without being dropped?

  • A. Set the tunnel IP MTU to 1500.
  • B. Set the tunnel tcp adjust-mss to 1360.
  • C. Set the tunnel IP MTU to 1400.
  • D. Set the tunnel tcp adjust-mss to 1460.

Answer: C

Explanation:
tcp adjust-mss is for tcp traffic only. TFTP is UDP.


NEW QUESTION # 147
Which feature of GETVPN is a limitation of DMVPN and FlexVPN?

  • A. sequence numbers that enable scalable replay checking
  • B. enabled use of ESP or AH
  • C. no requirement for an overlay routing protocol
  • D. design for use over public or private WAN

Answer: C

Explanation:
one benefit of GET VPN is Simplified network design due to leveraging of native routing infrastructure (no overlay routing protocol needed) f mismatch is causing the problem with the IPsec VPN


NEW QUESTION # 148
In a FlexVPN deployment, the spokes successfully connect to the hub, but spoke-to-spoke tunnels do not form. Which troubleshooting step solves the issue?

  • A. Verify the spoke configuration to check if the NHRP redirect is enabled.
  • B. Verify that the tunnel interface is contained within a VRF.
  • C. Verify the hub configuration to check if the NHRP shortcut is enabled.
  • D. Verify that the spoke receives redirect messages and sends resolution requests.

Answer: D

Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_conn_dmvpn/configuration/15-mt/sec- conn-dmvpn-15-mt-book/sec-conn-dmvpn-summ-maps.pdf


NEW QUESTION # 149

Refer to the exhibit. The IKEv2 site-to-site VPN tunnel between two routers is down. Based on the debug output, which type of mismatch is the problem?

  • A. ikev2 proposal
  • B. transform set
  • C. peer identity
  • D. preshared key

Answer: C

Explanation:
Section: Troubleshooting using ASDM and CLI


NEW QUESTION # 150
A network administrator wants the Cisco ASA to automatically start downloading the Cisco AnyConnect client without prompting the user to select between WebVPN or AnyConnect. Which command accomplishes this task?

  • A. anyconnect modules value default
  • B. anyconnect ssl df-bit-ignore enable
  • C. anyconnect ask none default anyconnect
  • D. anyconnect ask enable default anyconnect

Answer: C


NEW QUESTION # 151
An engineer is troubleshooting a new DMVPN setup on a Cisco IOS router. After the show crypto isakmp sa command is issued, a response is returned of "MM_NO_STATE." Why does this failure occur?

  • A. Tunnel protection is not applied to the DMVPN tunnel.
  • B. The Phase 1 policy does not match on both devices.
  • C. The ISAKMP policy priority values are invalid.
  • D. ESP traffic is being dropped.

Answer: D


NEW QUESTION # 152
Refer to the exhibit.

The customer must launch Cisco AnyConnect in the RDP machine. Which IOS configuration accomplishes this task?

  • A. Option A
  • B. Option C
  • C. Option D
  • D. Option B

Answer: B


NEW QUESTION # 153
A network engineer must design a remote access solution to allow contractors to access internal servers. These contractors do not have permissions to install applications on their computers. Which VPN solution should be used in this design?

  • A. Clientless
  • B. IKEv2 AnyConnect
  • C. SSL AnyConnect
  • D. Port forwarding

Answer: A


NEW QUESTION # 154
Which feature allows the ASA to handle nonstandard applications and web resources so that they display correctly over a clientless SSL VPN connection?

  • A. single sign-on
  • B. Smart Tunnel
  • C. WebType ACL
  • D. plug-ins

Answer: B

Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/security/asa/asa90/configuration/guide/asa_90_cli_config/ vpn_clientless_ssl.html#29951


NEW QUESTION # 155
When a FlexVPN is configured, which two components must be configured for IKEv2? (Choose two.)

  • A. profile
  • B. preference
  • C. method
  • D. proposal
  • E. persistence

Answer: A,D


NEW QUESTION # 156
Why must a network engineer avoid usage of the default X.509 certificate when implementing clientless SSLVPN on an ASA?

  • A. The certificate is regenerated at each reboot.
  • B. The default X.509 certificate is not supported for SSLVPN.
  • C. The certificate must be managed by the local CA.
  • D. The certificate is too weak to provide adequate security.

Answer: A

Explanation:
By default, the ASA generates a self-signed X.509 certificate upon startup. This certificate is used in order to serve client connections by default. It is not recommended to use this certificate because its authenticity cannot be verified by the browser. Furthermore, this certificate is regenerated upon each reboot so it changes after each reboot. https://www.cisco.com/c/en/us/support/docs/security-vpn/webvpn-ssl-vpn/119417-config-asa-00.html


NEW QUESTION # 157
......


Cisco 300-730 certification exam is designed for IT professionals who specialize in network security and virtual private networks (VPNs). 300-730 exam measures the candidate's knowledge and skills in implementing secure solutions with VPNs, specifically using Cisco technologies. 300-730 exam covers various topics such as secure communications, access control, and security policies.


Cisco 300-730 certification exam is a 90-minute exam that consists of 60-70 questions. 300-730 exam is available in English and Japanese and can be taken at any Pearson VUE testing center worldwide. Candidates who pass the exam will receive the Cisco Certified Specialist - Security Implementing Secure Solutions with Virtual Private Networks certification, which is a valuable credential in the IT industry and demonstrates the candidate's expertise in implementing secure VPN solutions.


Cisco 300-730 exam comprises of 60-70 multiple-choice questions, and you have 90 minutes to complete it. 300-730 exam tests your knowledge in various areas such as VPN technologies, encryption, authentication, authorization, and accounting (AAA), and network security. 300-730 exam is available in English and Japanese, and you can take it at any Pearson VUE testing center worldwide.

 

Latest Cisco 300-730 Dumps with Test Engine and PDF: https://actualanswers.testsdumps.com/300-730_real-exam-dumps.html